Recent Posts

51

General Discussion / Getting HAI Accessory to Trigger HomeKit Automation with Myro Helper

« Last post by DANNER on January 17, 2020, 10:30:36 pm »

I've been very happy with Myro:Home Helper.  It's well designed and reliable.  It's so great to be able to integrate my existing OmniPro with the HomeKit app and other HomeKit accessories.

One problem: I haven't been able to get the HAI accessories bridged with HAP to trigger any  HomeKit automation I've set up.  For instance, I'd like a UPB switch hooked up to the HAI system to be able to turn on a non-HAI controlled light that's connected via HomeKit.   Setting up an automation action to trigger when toggling the switch doesn't seem to trigger any automation (regardless of whether it's a HAI controlled accessory or a some other non-HAI HomeKit accessory)

Is this just a limitation of Home Helper?  Or is there something I'm missing in how I've setup my HAP server?

52

General Discussion / Re: Pandora refuses to stay "paused"

« Last post by Myro Control on December 20, 2019, 01:32:54 pm »

Hi!  Yes, it will auto resume if on the Pandora source... however, it should timeout if no controller is tuned to that source and/or the system is off.

53

General Discussion / Pandora refuses to stay "paused"

« Last post by jirapon on December 09, 2019, 03:20:51 am »

Using the My:Ro bridge with a Sonos sourcing to a Russound MCA-C3 and MDK-C6 keypads and the android Sonos app. It seems that although I pause the music stream in the Sonos app, it will eventually "un-pause" itself. I deduce this because although I pause the stream and power off the MCA-C3, when I check the app later, it is no longer paused. Is this related to the my:ro feature allowing uninterrupted play of Pandora? Is there a problem with letting the Pandora stream even without any amplifiers/speakers on? I want to be respectful and not cause Pandora royalty fees for music when I'm not listening. This doesn't happen with other music channels in my Sonos. (i.e. google play, music on device, etc) Any thoughts? Insights?
เล่นคาสิโนufabet

54

General Discussion / Re: Myro:Home / Myro:Home Helper for iOS / MacOS

« Last post by nicho03561 on November 29, 2019, 02:56:18 am »

wowwww!!!
this topic is so useful for me
thank you so much bro

แทงบอลออนไลน์

55

Report a Bug / Controlling Leviton ZWave Dimmers - Incorrect

« Last post by georgek on November 18, 2019, 08:01:39 pm »

First and foremost, great app!

Control tab All tab does not  accurately reflect current state of Z-WAVE switches.     
I have several dimmers, switches (non-dim) and receptacles.    Some are activated by scheduled timers e.g. turn landscape light on 10 minutes before sunset.     Control tab shows Landscape as off after event occurs.

Another issue is with a dimmer switch. 
Scenario:  Dimmer is at 52%.  Drag slider bar to 100% does not change brightness.   Slider goes to zero (status flashes off) then goes top 100 although brightness does not change.     Usually resets  status and slider bar to current dim level in a few seconds.   

Sliding to other brightness levels less than 100 works most of the time.     Once you slide to 100 the app is unpredictable.   App seems to get out of sync with controller after several adjustments.    e.g. app show 90% and the lights are actually @ 22%.

Does one need to wait a few seconds between commands with Zwave devices?

Configuration:
iPhone X iOS 13.1.3
OmniPro IIe with 3.9 firmware
Leviton Zwave controller plugged into Serial Port 1 on OmniPro IIe

Installed demo version, deleted and installed full annual subscription (still in trial period)

56

General Discussion / Re: App settings

« Last post by Myro Control on October 22, 2019, 01:32:21 pm »

Thanks!

To get back to the controller list, you can either double tap on the controller name or swipe down starting at the controller name when on the status tab.

57

General Discussion / Re: I have a question about 'myro:air'

« Last post by Myro Control on October 22, 2019, 01:30:57 pm »

Hi!

The USB port is meant to plug in the iPhone/iPad directly into it.

As for metadata, correct, it will send the metadata and transport control to the RNET (like an iBridge Dock did).

Thanks,
Danny

58

General Discussion / I have a question about 'myro:air'

« Last post by indigo01 on October 21, 2019, 03:13:33 am »

Can you plug a usb device directly to the myro:air?
.
and Does it provide metadata on uno-s2 keypads (russound cav 6.6)?

59

General Discussion / App settings

« Last post by kalinium on October 21, 2019, 01:27:09 am »

Hi,
Very nice discovering this app!
One thing got me confused. I can't seem to find the way to edit an account. When I first set the app I saw a panel view feature which I can't find anywhere now, as well as changing IP etc.
Thank you

60

General Discussion / Re: Long Live Myro:Air , Wishing upon a star : AirPlay 2 support

« Last post by RandomPlanet on September 24, 2019, 05:21:21 am »

I would certainly be in to get AirPlay2 Support ... Thanks !