Myro Control   |   Myro:Air   |   Myro:Bridge   |   Myro:Home   |   Contact   |   Support

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Myro Control

Pages: [1] 2 3
1
Tech Notes / FAQ / RS232 Control Protocol v1.1
« on: May 06, 2014, 10:59:21 am »
Here is version 1.1 of the RS232 commands for Myro:Air.

Features in GREEN available in firmware version 1.2.6 or higher.

Baud Rate: 9600
Data Bits: 8
Parity: None
Stop Bits: 1

REQ = Request
RES = Response

REQ: *IP_ADDRESS<cr>
RES: #4372|XXX.XXX.XXX.XXX<cr>
       
REQ: *VER<cr>
RES: #522|1.0.0/I2013082900469602<cr>
       
REQ: *NEXT_TRACK<cr>
RES: #4385|OK<cr>
       
REQ: *PREV_TRACK<cr>
RES: #4364|OK<cr>
       
REQ: *PAUSE<cr>
RES: #1220|OK<cr>
       
REQ: *PLAY<cr>
RES: #848|OK<cr>
       
REQ: *ALBUM<cr>
RES: #1218|[ALBUM TITLE]<cr>
       
REQ: *ARTIST<cr>
RES: #1783|[ARTIST TITLE]<cr>
       
REQ: *SONG<cr>
RES: #824|[SONG TITLE]<cr>
       
REQ: *STREAM_TYPE<cr>
RES: #5413|[STREAM_TYPE]<cr>
             
REQ: *ALL_META<cr>
RES: #2849|[STATUS_TEXT]|[ALBUM]|[ARTIST]|[SONG]|[ELAPSED_TIME]|[TOTAL_TIME]<cr>

REQ: *ELAPSED_TIME<cr>
RES: #6131|[ELAPSED_TIME]<cr>

REQ: *TOTAL_TIME<cr>
RES: #4402|[TOTAL_TIME]<cr>

REQ: *ALBUM_ART<cr>
RES: #3707|[ALBUM_ART_AVAILABLE]|[URL]<cr>
(** NOTE: [ALBUM_ART_AVAILABLE] = 0 for no, 1 for yes)

REQ: *STATUS<cr>
RES: #1796|[STREAM_TYPE]|[STATUS_TEXT]|[TRANSPORT_STATUS]<cr>  (example: #2A|Ready for AirPlay...|3<cr>)   

REQ: *DEVICE_NAME<cr>
RES: #5064|[DEVICE_NAME]<cr>
       
REQ: *MEM<cr>
RES: #498|[FREE MEM]<cr>

REQ: *ID<cr>
RES: #258|[ID]<cr>

EVENT WHEN TRACK CHANGES OR IS PLAYING UPDATES EVERY SECOND:
RES: @[STREAM_TYPE]|[STATUS_TEXT]|[TRANSPORT_STATUS]|[ALBUM]|[ARTIST]|[SONG]|[ELAPSED_TIME]|[TOTAL_TIME]|[ALBUM_ART_AVAILABLE]
(** NOTE: [ALBUM_ART_AVAILABLE] = 0 for no, 1 for yes)

EVENT WHEN ALBUM ART URL IS AVAILABLE:
RES: !|http://xxx.xxx.xxx.xxx/url_to_the_art.jpg

2
Firmware / Matrix Firmware v1.3.25
« on: May 04, 2014, 01:55:42 pm »
We have released v1.3.25 which does the following:

- Adds support for new Matrix Switchers

Please create a support ticket to get the firmware download tool -- please specific OSX or Windows.

3
Firmware / Sonos Firmware v2.2.2
« on: May 04, 2014, 01:54:09 pm »
We have released v2.2.2 which does the following:

- Fixed Rhapsody Queue Playstate issues
- Fixed behind metadata issue for XM
- Other minor performance fixes

Please create a support ticket to get the firmware download tool -- please specific OSX or Windows.

4
General Discussion / GIVEAWAY: Win a Myro:Air!
« on: May 03, 2014, 08:22:13 pm »
Enter to win a Myro:Air (valued at $599), that's right!  Visit Mavromatic for the details.

5
General Discussion / Myro:Air Featured on Revision3's Tekzilla Bites
« on: April 29, 2014, 09:44:11 am »
Here is a review of Myro:Air featured on Revision3's Tekzilla Bites (April 29, 2014):


6
Tech Notes / FAQ / Russound: Setting Myro:Link ID to RNET ID (Source)
« on: April 25, 2014, 08:48:46 am »
If you are setting up a Myro:Air to work with a Russound system, it has been tested to work with the following RNET based Russound systems:

- CAM
- CAV
- E-Series (Sphere)
- C-Series (C3/C5)

To use Myro:Air as a Russound "Smart Source" you need to setup as you would an "iBridge Dock".     Typical settings for CAV is setting the Command type as "Peripheral" and the Myro:Link ID to match the Source number (e.g. Myro:Air connected to Source 2 input, set Myro:Link ID to 2).

For E & C-Series systems, you setup the source in the windows system configuration software (SCS).  Select the source and apply the "iBridge Dock" template to the source input.

Please note: We advise not to connect Myro:Air to Source Input 1 (Myro:Link ID 1) because that is typically reserved for the built in AM/FM radio of the C3/C5.   We have also experienced issues with CAM/CAV when using ID 1.

7
Tech Notes / FAQ / Setting up Myro:Bridge with Sonos
« on: April 17, 2014, 03:15:59 pm »
The most common call we get is "I cannot get the metadata to show up on the keypad".

First, check out this typical connection diagram.

Next, check out this manual for Sonos Firmware Installation.

If you still have issues, please create a support ticket.

8
News & Announcements / PRESS: Residential Systems
« on: March 21, 2014, 08:32:54 am »
Residential Systems Magazine did a nice write up on Myro:Bridge.   

We have a Russound whole house audio system in our very own home and we're excited that we're helping other integrators add and extend the capabilities of Russound systems around the world!

9
Firmware / Firmware updates
« on: March 20, 2014, 08:52:41 pm »
While we design a better system to release firmware updates, please create a support ticket if you are in need of the latest firmware.

10
Here's a quick video showing how you can use the Myro:Bridge with a Sonos:Connect and control via the Russound iOS app or Keypad.


11
General Discussion / VIDEO: UPnP DMR Streaming from Android
« on: March 20, 2014, 08:44:00 pm »
Myro:Air supports AirPlay and UPnP DMR Streaming from PC and Android (or any device that support UPnP DMR).

Watch this video for more information:

12
General Discussion / Myro:Air AVS Forum Thread Link
« on: March 16, 2014, 01:40:41 pm »
In case you already have an AVS forum account, you can post your questions there as well.

http://www.avsforum.com/t/1472712/myro-air-airplay-upnp-streamer-with-wolfson-wm8741-dac/30

13
General Discussion / MOVED: Crestron Control Module
« on: March 16, 2014, 01:35:44 pm »

15
General Discussion / MOVED: RS232 Control Protocol
« on: March 16, 2014, 01:33:51 pm »

Pages: [1] 2 3