Myro:Bridge > General Discussion

Myro stops controlling KD matrix

<< < (2/2)

Myro Control:

--- Quote from: techelec on March 25, 2015, 04:49:53 pm ---Just another question first.  This system will work all day just fine, maybe two days, but at some point the video switching will cease.   I went there today and cycled power simultaneously to all components, still no switching.  If I "reboot" the bridge all is well again switching sources, etc.   Is there a way to make a power cycle a "reboot?"  It seems as thought the bridge needs to be rebooted occasionally to work. Can an issue with the RNET data cause this?   

Btw, there is no internet connection, but a router is connected and the Myro has the latest firmware for offline mode.  I cleared the Myro and reflashed it again last week with the same firmware.  It appears as though I have a Bridge that is going awry, but I want to make sure that the RNET data cannot corrupt it???  Reason I ask it that I am having issue with a command that sends  "PLAY"  to the Bluray player to wake it up when that source is selected.

--- End quote ---

You should never have to reboot a Myro:Bridge that has the Matrix Firmware installed, once it's up and running.   So the issue you are having could be related to EMI or something else.  I'd rather replace the unit than have you spend time troubleshooting this.   I can advanced ship a unit if needed as well.  Please create a support ticket with address and we'll get a unit shipped out.

Thanks!

techelec:
OK.  Thanks a bunch Danny!  will do the support ticket.

Navigation

[0] Message Index

[*] Previous page